Battery must be in good condition and fully charged​

All Ignition Keys present when programming (Some Vehicles) Ask if this applies.

Adequate work area where the doors and hood can be opened (out of direct sunlight if possible)

Leave the Old Module installed until the new module is ready to be installed and programmed. (Ford Only)

Keep the Old Module until the vehicle is running with the new module.

Is there scan tool communication with the old module and new module?

The reason the module is being replaced or updated? Recurring codes? TSB? No Start? 

The replacement module is new? used? reman? 

Where was the replacement module purchased? dealer? aftermarket? 

Do you have a PIN code to program the new computer? (Chrysler only)

Did the engine run with the old module?

Service Call Disclaimer: A $100 service charge may be applied if module is incorrect or cannot be programmed due to vehicle or module fault.